FAQs archivo - Vigilaweld

Q: Can I keep my old flow regulator - scale in liters / minute - (Bourdon or rotameter) to make the comparison of consumption?

YES ..., first , WITH THE GAS PASS IN THE SAME POSITION IN WHICH WAS WITHOUT THE VIGILA , we will measure the consumption by setting the WGC1 in flowmeter mode. When operating the WGC 1 in regulator mode, the GAS PASSAGE must be FULLY OPENED. The mechanical indicators in this case will not indicate correctly.

Q: Can I reduce the number of parts thrown away by gas failure?

One of the objectives we achieve with the WGC1 is the savings, but not the only one , as much or more interesting is the constant monitoring of the welding work as far as the gas is concerned, NOW ..we do not need to check seam by seam to know if the work has been enough gas, if there is a small parameters deviation, we will know immediately before a disastrous weld occurs.

Q: How do I find out if a problem or fault occurs?

We can set a maximum or minimum alarm threshold to the parameters we measure, each alarm can have several simultaneous actions... display flash, buzzer, relay contact closure ( and / or) gas closing... Actions ranging from the slightest alarm to the most serious alarm.